Is this the right place to ask for help? Or is there another place? Anyways, feel free to delete this post if i’m in the wrong spot.
I use Pop OS on an Asus. Something has happened where i either have a 10 min plus boot time, or it doesn’t boot at all. I have reinstalled Pop OS twice (and used recovery mode) and even took it into a computer shop to see if there was something wrong with my hardware (there isn’t). When I first do a new install it will restart fine, but then it’ll be the next day when it will either take over 8 minutes to load, or it will be stuck on boot.
Right now it is stuck on boot. I can get into a live usb stick just fine. I have done systemanalyze blame, and it didn’t give me any helpful information. I have the same issue even if I try to press space bar and boot into an old kernel.
I should note that my computer has encryption enabled.
Any help would be awesome.
All hail the other linux noobs out there!
can you post
journalctl -b0andsystemd-analyze blameresults from after a successful boot. i have broken and fixed my own systems countless ways so maybe i’ll spot somethinghttps://hastebin.ianhon.com/fc2c
thanks, can you please give me the output of
journalctl -b0 -u systemd-modules-loadi’m curious why it’s taking 30s. maybe the other two services as well
the dmesg you posted is very truncated, just like a screenful of info. you can usually pipe command output to curl with these pastebin sites. i understand if you’re concerned about sensitive info in dmesg though
j@pop-os:~$ journalctl -b0 -u systemd-modules-load
Dec 07 12:45:50 pop-os systemd-modules-load[614]: Inserted module ‘lp’ Dec 07 12:45:50 pop-os systemd-modules-load[614]: Inserted module ‘ppdev’ Dec 07 12:45:50 pop-os systemd-modules-load[614]: Inserted module ‘parport_pc’ Dec 07 12:45:50 pop-os systemd-modules-load[614]: Inserted module ‘msr’ Dec 07 12:45:50 pop-os systemd-modules-load[614]: Inserted module ‘kyber_iosched’ Dec 07 12:45:50 pop-os systemd[1]: Finished Load Kernel Modules.
you can also
journalctl -b0 -p4to show only high priority messages. that would help toohttps://pastebin.com/6ih7pHwZ like this?
it’s very hard to decipher. the lines are right-truncated like you just copy-pasted from the terminal (the lines end in
>which is less’s sigil for “more content to the right”). you can make a pastebin from command output. to capture any command as a paste trythe part after the
|comes from here:https://dpaste.com/FZNXRMS75
you can put anything before
|to capture it to dpaste. check it for sensitive information first!from what i can see though, your nvme is behaving strangely. it may be related to power saving settings. try these settings from the Arch wiki:
https://wiki.archlinux.org/title/Solid_state_drive/NVMe#Troubleshooting
do you boot from the nvme?
I am currently on this computer but booted into an old kernal which was still slow to load but eventually got me on