Yesterday a divine miracle happened and a wild Xbox360 S phased into reality in my apartment. What cool and neat things I can do with it?

  • imetators@lemmy.dbzer0.comOP
    link
    fedilink
    English
    arrow-up
    6
    ·
    1 day ago

    I possess soldering skills so that is no issue.

    I been reading and things are confusing for me. Some say that I only need 2 wires to run across the motherboard and run ABadAvatar. But if I read ConsoleMods wiki, it seems that I need a programmer. I have ordered rpi pico for this and will dive into it once I figure out the process.

    • Jestzer@lemmy.world
      link
      fedilink
      English
      arrow-up
      3
      ·
      1 day ago

      I know things have changed since I last did an RGH setup, which is probably where the confusion comes from; things are changing even though the scene was most active 10+ years ago.

      I imagine you don’t need a NAND flasher now that ABadAvatar exists, but I could be mistaken. The process used to be, at a really high level: solder the NAND flasher/dumper, dump the original NAND, solder the RGH timer, then flash a NAND with a good timing profile for that console.

    • milk@discuss.tchncs.de
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 day ago

      With RGH3 you technically don’t absolutely need a flasher since you can technically flash from within the BadUpdate jailbreak, but a flasher is nice if you need to recover the nand if something goes wrong.

      But you may want to consider just going the BadAvatar route. My soldering skills are above average after university but if you’re not used to SMD stuff you will struggle. BadAvatar takes less than a minute and will boot you into Aurora right after it finishes.

      Its also worth noting that some later slims can’t be hardmodded at all so just look out for that. I would recommend the consolemods wiki and if you look on YouTube you’re bound to find some resources

      • imetators@lemmy.dbzer0.comOP
        link
        fedilink
        English
        arrow-up
        2
        ·
        16 hours ago

        My model is Trinity. Apparently, the easiest to RGH3 it. My soldering skills are above average. I possess needed tools and components.

        I thought to just do ABadAvatar too but I still wanted to disassemble Xbox to change thermal paste and clean dust. So might as well solder 2 wires and a resistor while at it. This console will never be used with ms account anyway so why the hell not to hard hack it? 😅