Hi DIY!
My headphones of many years recently broke. My first response was to attempt to glue them back together with super glue (ethyl 2-cyanoacrylate) however that didn’t seem to hold. Not even a little bit.
I then did a bit of searching and found that Sony often use ABS plastic in headphone manufacture, so presumably these are ABS. I then read super glue should work okay on ABS, however there seemed to be no bonding happening at all.
Do any of you have any tips for the best kind of glue or epoxy to bond these plastic parts back together and get the music flowing again?
I plan on wrapping the joints in thread afterwards, for additional durability. But first I need to get them bonded.
Loc-Tite Plastic Bonder has worked well for me in these situations, but sometimes it just doesn’t seem to take well; other times it holds better than the original plastic does. Worth a shot?
This looks like Loc-Tite’s version of the JB Weld Plasticweld. If I can’t find any JB then I’ll give this a go, thanks!