I used a 10mm masonry bit to drill for a 10mm plastic anchor like that pictured. The anchor spins freely in the hole, which I think is expected. I thought I read somewhere that the screw size should be 2mm less than the anchor. Thus 8mm for a 10mm ø anchor. But an 8mm screw is fat enough to rub sides of the anchor as it is inserted because I suppose the anchor is only 1mm thick at the opening. The guy at the shop confirmed that 8mm is too big. He said a 6mm screw matches and sold me those. After installing and loading, the anchor started to pull out.

Do I need a 7mm ø screw? Odd sizes get decreasingly common above 5mm. Yet 10mm sleeves are very common… so it’s not adding up.

I would like to have a reliable PDF chart of bore,anchor, and screw sizes – in metric. It seems there are plenty of such charts for Imperial/English units, like these:

I’m not sure what a “#10” screw or anchor is. Does that refer to the metric size despite being in an imperial system.

  • Canonical_Warlock@lemmy.dbzer0.comEnglish
    0·
    8 小时前

    These anchors are designed to be tight in the hole before you even put a screw in. If it spins freely then the hole is too large and you need a larger anchor. When in the hole the anchor should fit fairly snuggly on it’s own.