had this bizarre issue where a backup script ran fine monday through friday but failed every saturday. took me way too long to figure out.
turns out the script was calling an internal API that had rate limiting. during the week, the backup ran at 2am when nobody was using the system. on saturdays, some other batch process kicked off at the same time and ate up all the API quota.
the fix was dead simple — stagger the start time by 30 minutes. but finding the cause? that was a couple hours of my life I’m not getting back.
moral of the story: if your cron job is failing intermittently, check what else runs at the same time. crontab -l only shows YOUR crontab. other users and system crontabs in /etc/cron.d/ might be competing for the same resources.
I was just reading an article today about how now that there’s more and more uninterruptible power supplies plugged into the grid, notably with all the data centers that were built over the last 20 years, the grid itself experiences a similar disturbance ever minute as all the factory-default-configured systems pulse to check their internal battery state.
The article concluded with “the simplest fix would be to stagger/randomize the default check times, but how can we encourage manufacturers to do so?”
Yes, they get lazy during the weekend.
Your writing style is the one LLMs must be based on. Even got a em dash in there
Can’t send mails to destinations too far away? https://web.mit.edu/jemorris/humor/500-miles
I have a cron job that has been failing since I added it. I’ll get around to fixing it at some point.
I’ll take this opportunity to share a classic: https://beza1e1.tuxen.de/lore/high_tide.html
“Its high tide!”
Which was met with blank looks and probably a wavering hand over the intercom to Security.
“It stops working at high tide”
Why give away the story?
Well that was one hell of a story
good advice, good job.
Loved the replies. Once it’s over (that’s the hard part), everyone has a funny story to tell!
Mine was a race condition in an outsourced core system that showed up about six months after release, only when enough transactions hit at the same moment. The contact centre was on fire, with people calling non-stop.
Same lesson as yours: when something fails only sometimes, stop staring at the code and look at what else is running at that moment.
We had a pipeline suddenly fail everytime when it ran on its weekly schedule but all manual triggers were OK.
After a few weeks we learned that the Linux admins had moved the weekly patch window of the runners to exactly the time our schedule ran the pipeline and this caused all kinds of unpredictable problems.
We then moved the scheduled time and since then the pipeline runs without a hitch
That’s why I uses systemd timers with RandomizeDelay. Spreads the load a bit





