• Matt@lemdro.id
    link
    fedilink
    English
    arrow-up
    3
    ·
    13 hours ago

    There are rechargeable AA batteries. I prefer this over built-in batteries because I can swap the batteries out immediately instead of waiting for the controller to charge. It is also cheaper and easier to replace the batteries when they eventually begin to wear out.

    • Fubarberry@sopuli.xyzOPM
      link
      fedilink
      English
      arrow-up
      1
      ·
      9 hours ago

      What kind of rechargeable AA batteries do you use? I’ve tried a lot over the years for wiimotes/other controllers, but the battery life is kinda terrible.

      The new steam controller is supposed to have 35 hours of battery life, I seem to remember my rechargeable AA powered controllers only getting like 2-4 hours per charge. They might have gotten 4-6 hours when they were new, but it wasn’t much better. Seems like even if the steam controller battery deteriorates to 50% capacity (17.5 hours) that would still be far better than my results with rechargeable AA batteries.

      • Matt@lemdro.id
        link
        fedilink
        English
        arrow-up
        2
        ·
        9 hours ago

        I use Eneloop batteries. They are widely regarded as the best quality and I have never had a problem with any of them.

        The only controller I have that uses AA batteries is an Xbox controller. I am a fairly light gamer, so I have never measured how many hours they last, but I have no complaints about battery life. I often get more than a month of use before needing to charge them, so I would easily guess at least 10-20 hours of battery life.

        • Fubarberry@sopuli.xyzOPM
          link
          fedilink
          English
          arrow-up
          1
          ·
          9 hours ago

          I did some reading on it after posting my comment, it sounds like there’s been a pretty major improvement in rechargeable AA batteries in the last 10 years. Capacity has improved by 70+%, and much less power is lost during standby. So it’s probably worth trying again, I had just been avoiding them due to how poor the performance was back then.